Cut Strips
Available from our full range of boards, cut to any variables in size.

Cutting A fine tooth hand saw or a power saw are recommended. Ensure blade is tungsten carbide or diamond dusted.

Support both ends of the board when cutting to avoid breakaway.

When drilling, cutting or sanding with cement manufactured products, wear safety glasses and approved dust mask or respirator.

During clean up, contain dust by vacuum or wet down methods. Safe disposal again requires containment of dust.

Other suitable general health and safety issues should be implemented.

Handling
When handling individual boards from stack, slide sideways and lift by spread arms on long edges to give even support and prevent excessive flexing of the board.

Storage
Always stack boards on a smooth flat level surface. Protect edges from chipping.

If boards need to be stacked, always ensure blocks properly align.

Loose storage of boards on their edges is not recommended.

Cover boards to keep dry prior to fixing.
If sheets become wet, allow to dry thoroughly before fixing.

Full consideration has been taken to ensure information put forward within this literature is accurate at time of going to press. Roofing and Cladding Materials Ltd cannot be held responsible for omissions, errors or for information which is found to be misleading. Roofing and Cladding Materials Ltd reserve the right to alter products and specifications without prior notice.